Rerurn to Romy the Cat's Site
In the Forum: Audio Discussions
In the Thread: It’s mad, mad, mad... electricity.
Post Subject: Commercial Cable OptionsPosted by Paul S on: 4/20/2021
Alex, I "invented" and built my own power cables from scratch, using sleeved, solid, 12AWG Cu magnet wire, as I explained to Jarek, way up this thread. If buying pre-fab cables, I would first consider Speltz. As for "oiling" the wire, I don't know about this, although I did use a heat gun to melt bees wax into my homemade Litz-braided IC, and it did not cause any problems I have detected. I have done a lot of complaining here about poor connectors used for even the most expensive cables. I think I posted a link to a metals conductivity chart up this thread, as well. For example, Switchcraft connectors are not the worst, I suppose, but not the best, either, IMO. The main problem seems to be, no one can afford to make their own connectors, and the companies who can afford to make them care more about their own manufacturing processes than audiophile issues. Although "we" (hi-fi nuts) like to think someone is "making a killing" on high-end audio gear, this "market" barely blips on the "parts industry" radar. It's flat out hard (and so, hardly worth it) to get "good parts" to make good cable. As ever, the path of least resistance is to make something from what's available and use "the system" to hype it, sell what you can, then move on to something "better".
Best regards,
Paul SRerurn to Romy the Cat's Site