Rerurn to Romy the Cat's Site


In the Forum: Audio Discussions
In the Thread: Input choke for Low Currents?
Post Subject: Re: Input choke for Low Currents?Posted by hagtech on: 3/7/2006
Hi Cat.  I run the 12AX7s just a hair over 1mA each, and the 12AU7s at 6mA.  With differential pairs and bleeders, it ends up at 39mA on each +/-300V rail.  That works out to 7H minimum inductance at 60Hz, using the standard formula.  You can use my online web calculator as a shortcut (www.hagtech.com/theory.html#choke). 

Without enough inductance (the first L), then current can become discontinuous and output voltage a bit uncontrolled.  As you point out, it takes a solid load to make these things regulate properly.  I do the same thing on the heaters.  In addition, I add series resistance with the inductors to tune them for damped response with the loading capacitors.  This is very important if you don't want an LC tank oscillation - unstable output impedance.  Basically, you have to tune everything simultaneously for current, voltage, and damping. 

I added yet another trick with shortened tails on the differential pairs.  They match the plate voltage such that if there is a change in line voltage (short duration), the dc voltage out the plate stays constant.  I guess you can call this passive regulation.  Don't think anyone else has come up with this yet.  It's amazing to see it in action.  I can put a scope probe on the plate (output) of each 12AX7, vary the ac with a variac and the plate voltage doesn't move.  This will not happen with normal SE or traditional balanced stages (worst with current source).

jh

Rerurn to Romy the Cat's Site