GoodSoundClub - Romy the Cat's Audio Site

In the Forum: Horn-Loaded Speakers
In the Thread: Another horn manufacturer

Post Subject: Reply to the CatPosted by zztop7 on: 4/18/2013

I think that $5K-$7K might be adequate for the project if no profit was involved. Different path: CNC for the mold, but fiberglass boat style construction - gel coat, chopped fiberglass, dense closed cell spray in foam for structural strength, final coat of glass etc. / or use carbon fiber instead of fiberglass. The carbon fiber would not have to be a layup. Newer Lamborghinis & Callaway golf clubs are using an easier system developed at the University of Washington. This production would not have the typical exterior horn appearance; it would be an exterior block appearance. The interior horn layout would be as you the Cat described.Best to you,zz.

Rerurn to Romy the Cat's Site