|
Romy the Cat's
personal site dedicated to advanced audio and evolved music reproduction
techniques
|
|
|
|
|
I was stressing a couple days ago in Reed’s threads a point that the effective mass of tonearms itself is irrelevant for this type of cartridges. There is absolutely no sense to change tonearm just because you would like to have “slightly higher mas...
|
Dear Paul,Generally I can say a lot lower sound floor, You hear more detail with less compression. Very open. I compared it with Mayajima Shilabe and Ortofon Royal N, with Ortofon 12", SME 3012 and TW Raven tone arms. As you see I'm using "heavy" arm...
|
It is good that you like that Lithuania new tonearm. A local guy of my who has it also like but I do not like him…. Unfortunately I am not on the tonearm market or I would try it against my beloved absolute reference – the 3012....I know it is very...
|
A site reader sent me email: “ …some guys in Germany & Japan have put it [Micro RX5000] up against the Continuum and other ultra expensive high end tables with older vintage arms similar to your SME 3012 and shamed the newer tables.... “I asked a...
|
[quote user="drdna"] The Decca London Reference appears ideal. I am probably going to buy one of these. Romy, you are free to borrow it if you wish to listen to it; just do not break it. [/quote]
Possible it is a good cartridge, I do not...
|
[quote user="starboy"] Romy wrote... He will go away over it in a few years...
That he may just like Fannie mac or whatever, until then I guess he will be hand making those carts in his workshop. [/quote]
Actually it was my typical mistype. I met t...
|
Hi All, 103 or 103R + mass loaded SME headshell + 3012 or a 3009 + Seiki 1500 + hagerman opamp phono stage (good only with select parts and battery power) or an EAR 834 (with some mods) and some old Altec mic t...
|
Koetsu are crap and it is sad that some ognorant or criminal people crated so much hype about it. Might be in past it was better, as it was proposed above by somebody in this thread, but I doubt as I know people who drooled about Koetsu 20 years back...
|
Stitch,
the only thing that you are missing is paying attention to the OMA advertisements and truing to recognize behind it any rational beside a pimp yearling own merchandise (in fact it is not his merchandises). I told many times before tha...
|
Following on from my last two posts, I finally managed to try the Model Two in AD mode. With the Model Two set to 24/4fs and wordclock master, I cannot discern a difference between the source and the source passing through the Model Twos AD/DA. Furth...
|
Dear Romy, thanks for your comment. I actually don't want the mat to do "something" for me sonically, but to teach me how far I'm I of my ideal. Knowing your goals and taking for granted that the 8000's platter must be rather dead sonically, I assume...
|
I have no experiences or knowledge on this dependency but I have seen people who were trying to say that it exists. Perhaps is does exists but I feel that it exists only in the world of bad designs. Like the noisy TT could be “fixed” with arm with be...
|
I lately look at the noise created around the Shelter cartridges and I wonder what is going on. Shelter was doing wonderful cartridges, more or less responsibly priced and people use it for years. Bunch of the typical industry scams in past did their...
|
Sometimes ago I received an email from a NY guy that I know:
“I borrowed a friend's Sansui TU-X1 and just like I heard them at your place it sounds fantastic! What is it about this tuner? There is such an ease to the presentation and no distra...
|
Romy,I use Ortofon Rondo Bronze with Nottingham Spacearm and Spacedeck. I hate Spacearm because bad tracking. Also, I can't add mass to Spacearm.I going to try a heavy tonearm.Fidelity Research FR-64FX with Ortofon Rondo Bronze (compliance is 15mm/uN...
|
Hi, [quote user="Chirag"]103 or 103R + mass loaded SME headshell + 3012 or a 3009 + Seiki 1500 + hagerman opamp phono stage (good only with select parts and battery power) or an EAR 834 (with some mods) and some old...
|
After more than 10 years of using the Micro Seiki MAX-282 tonearm I realized that if it is my second stereo arm then why I presume it shall have Second Sound? I have properly performing mono and stereo arms and I have a dally arm. The Daily arm is a ...
|
[quote user="Antonio J."]I knew that my asking about the cart used would make you to write the kind of comment you've done. What I've enjoyed most and exclusively of the disc has been the music, all are terrific pieces and some, like the Ko...
|
[quote user="Romy the Cat"]We are at severe devaluation of reference points and nowadays any Moron with a rudimental knowledge of HTML and a few vocal cronies can become a “reputed manufacturer”. [/quote]Hi Romy, it is even worse. Based on the high n...
|
Alex, the best version would be the first (Series 1) version but these are very rare. Next best would be the pre-Improved Series 2, having metal knife-edge bearings. The Improved would be OK for light-weight, light-tracking MM carts, having been deve...
|
What you have there Romy is essentially the cartridge Ortofon introduced in 1948, the first production moving coil cartridge.
The motor is the same, just the "suspension" material changed from india rubber to a modern elastomer AFAIK. Also the G-sty...
|
[quote user="Romy the Cat"] The anti-skating force
pulls arm outward? Sorry, I very much degree. In any arm that I have seen and
that makes any sense, including the classic SME arms the anti-skating force pushes
arms toward to middle. I think it i...
|
Romy,
I don't know if you have seen this effort by a gentleman in Greece. As I said, I'm not really a fan of the high mass approach. (I've listened to a few but generally find them tonally unbalanced) This design seems to take that approach qui...
|
Since my “End of Life" Phonostage have materialized I got exposed to a temptation of finding a “right” cable between my tonearm to the phonostage. The most critical cable between the step-up transformer and phonostage does not exist in my system anym...
|
[quote user="drdna"]…Sorry for your disappointing experience. [/quote]
Why was it a disappointing experience? I was not. It might be disappointing for him – he did close the sale, but it was not disappointing for me.
I read his comments about his ...
|
This new “Rev B” Ortofone Jubilee surprised me with it amassing agreeability
I have a nasty habit to emphasize in my listening attention the things that I do not appreciate. I might listen something, would it be amp, or speaker, or live event,...
|
[quote user="hifitodd"]I'm trying to get my head around the tonearm/cartridge matching mechanics.First of all, are ALL cartridges much happier with a heavier tonearm? Even cartridges with a high compliance?My understanding of a "correct" arm ef...
|
I was taking lately with the Blue Angel’s Andre and kept asking him about his cartridge’s bass. He got “scared” and asked me if I am looking for overly-anaphased bass, then he asked what kind music I am listening. I perfectly understand why he got “s...
|
[quote user="Antonio J."]Well, I don't know if there's something wrong with the platter and I'd like to know it. All I know is that lower bass has kind of "detachement" from the mid-upper bass, that I don't hear from the tuner nor the DAC. [/quote]
...
|
Folks, This thread caught my attention, because here Romy waxes lyrically about the failings of the Denon Cartridges. Now I only consider ONE Denon worth bothering, the ORIGINAL 103, it is often inaccuratly called 103C. It has a medium compliance (ar...
|
|
|
|
All context of this site except the Forum's posts
Copyright © Roman Bessnow 2004-2024
All messages within the Site’s Forum Copyright © by
authors of the posts
|
Last 24-hours posts: |
0 |
|
|
|
Total human visitors: |
42,874,606 |
|
|
|
|
|
|
|
|
|
von Biber, Heinrich Ignaz »
|
Gaßmann, Florian Leop»
|
Krumpholz, Johann Baptist »
|
Adam, Adolphe-Charles (24 »
|
Tcherepnin, Nikolai (3 May»
|
Cherepnin, Nikolai (3 May »
|
Dupré, Marcel (3 May »
|
Huízar, Candelario (2»
|
Savel'ev, Boris Vladim»
|
Fampas, Dimitri (22 Decemb»
|
Kröll, Georg (3 May 1»
|
Harvey, Jonathan (3 May 19»
|
Kan-no, Shigeru (3 May 195»
|
|
|
|
|